Eaglemaster

CL 5000T

Operation instruction

Remote function

Remote function by press two buttons

Function operation:

Arm/Car search by chirps: Press 1 button, siren chirp once and lights flash once, doors locked and start killed, alarm will be triggered whenever the car was hit or intruded. When press 1 button again, siren will chirping 4 times to car search by chirps.

Disarm: Press 2 button, siren chirps twice and lights flash 3 times, doors unlocked and start killer released.

Panic: Press 4 button twice in Arm position, siren will keep blowing and light keep flashing 30 seconds, until press 2 button to turn off panic mode.

Anti-Car Jack: When Ignition on, Press 4 button twice, it will triggered anti-car jack. Light flash 20 seconds to show the car is entering into anti-jacking mode.

Extra sensor by pass: Press button 1+2 while in Arm position. Siren chirp once to confirm the alarm is extra sensor by pass. Press buttons again siren chirp twice to turn off this feature.

Sensor by pass: Press button 1+3 while in Arm position. Siren chirp once to confirm the alarm is sensor by pass. Press buttons again siren chirp twice to turn off this feature.

All sensors by pass: Press button 1+4 while in Arm position. Siren chirp once to confirm the alarm is all sensor by pass. Press buttons again siren chirp twice to turn off this feature.

Valet mode: Press button 2+3 while in Acc on position. Siren chirp twice to confirm the alarm in Valet mode. Press buttons again siren chirp 3 times to turn off this feature.

Door opened alert: Press 2+4 while in Disarm position. Siren chirp once to confirm the door open warning signal during Acc on. Press buttons again to turn off this feature.

Dome light alert delay: Press button 3+4 while in Disarm position. Siren chirp once to confirm dome light alert delay for 20 seconds while disarmed. Press buttons again siren chirp twice to turn off this feature.

How to use code learning:

This system can expand to different transmitters, and comes from factory with two transmitters already programmed into the system memory. Whenever you want to add or delete transmitter code of the system, just obey the following instruction.

1. Turn Acc from Off to On and push S3-Tact switch (refer to wiring schematic) at the same time.
2. During step #1, press over-ride switch On/Off. Siren will chirping twice to confirm system in code learning mode.
3. Press any button of new transmitter for learning, siren burst once and chirp once to confirm the code of first transmitter is learned.
4. To program the second, third or fourth transmitter codes, repeat step #3. Siren chirps to confirm each transmitter is learned.
5. Turn Acc off or 10 seconds for no transmitter activity, alarm system will automatically turn off the code learning program and siren will burst twice.
6. Every time learning new transmitter, formal code (old transmitter) will be erased, hence old transmitter must also learning again when new transmitter need to learn.

Special features:

Anti-Car jacking: When Acc on, press button 4 twice, Lights will start flashing to show the car is entering into anti-jacking mode. 20 seconds later, siren chirps every 5 seconds for 4 times to pre-warn user. Then siren blow for 20 seconds later start killed, until press over-ride switch in Acc on, or press button 2 to turn off anti-car jack.

Auto Re-Arming: Alarm arms again 30 seconds after disarm, unless the doors have been opened or engine is ignition on. This feature is to avoid mis-touch or mis-disarmed.

Audible zone violated identification while Disarming: If the car is attempted or intruded, the siren will chirp different sounds to identify which zone has been triggered.

* Siren chirps 3 times - sensor was triggered for light touch *Siren chirps 4 times - Sensor was triggered for heavy impact or current was triggered. *Siren chirps 5 times - Extra sensor was triggered. *Siren chirps 6 times - Door or Acc was triggered.

Audible Defective zone alert & By - Pass while Arming: I arming alarm mode if the siren chirps 4 times, it means that door(s) is not shut properly. The alarm will by pass that zone but it will still protect other zones.

Emergency over-ride switch: If the remote has been lost or damage, the owner can enter the car by the key. It will act the alarm. To disarm the alarm turn ignition on and press over-ride, it will disarm the alarm instantly.

Remote sensor by pass: Press sensor by pass buttons, siren will chirp once to confirm that the sensor(s) will not be detected, but it will be detected again next arming.

All time remote lock / unlock operation: regardless Arm or Disarm, lock and unlock operation will work any time.

Dual level electronic shock sensor: 10 chirps for light touch, heavy impact will cause full alarm. During the 10 chirps period, if 2nd impact is detected siren will blow 15 seconds.

Trunk Auxiliary or Remote starter: Keep press button 2 for over 2 seconds then trunk or starter been acted.

Arm condition memory: Whenever cut off the power supply from battery, alarm still keep memory of arming, when power is on again alarm triggered immediately, siren blow, lights flash and starter killer still in arm status. (When in normal status, Power off then on again, alarm still in normal status, never cause trouble in maintenance garage).

Anti-scaning: CPU of alarm receiving correct code may not respond immediately unless continuously more code have been confirmed. This conservative attitude keep the system disarmed by scanner.

Last door arming (selectable by jumper S1): If enable, alarm will arming automatically 30 seconds after the last door is closed (to prevent the doors been lock, it will only arm and the doors won not be locked).

Ignition safety door lock (selectable by jumper S4): When turn Ignition On after 10 seconds, the doors will lock automatically, but within 10 seconds the door was opened this "safety door lock" will be canceled. When turn Acc off, the doors will unlock immediately.

Passive Immobilizing function (selectable by jumper S2): If set to "Enable" (1). Turn Acc off (2). LED fast flashing, 120 seconds later start killed then LED pluses slowly enter "Immobilizing mode" but during 120 seconds when door(s) have been opened start killed instantly. (*To turn off immobilizer, press disarm 2 button)

Pager output: Pager (+) output (2Amp) can be connected to arm pager to become 2 way service.

Door lock delay timer (selectable by jumper S0): the default lock timer is 0,8 seconds. The 3,5 seconds is for vacuum type of central door lock system. Just tack off jumper S0.

Parking lights relay built-in

Central lock relay built-in: This is available for any different design of door lock/unlock

LED Visual status identification: When you disarm the alarm, a fast pulses on the LED indicator will visually alert you if an instruction attempt was foiled while you were away. It will reset it self after Ignition has been turn on.

Jumper selection setting table:

WIRING DIAGRAM